This technical guide is intended essentially for bridge designers. It provides the information required for the design of elastomeric pot bearings for use on road bridges and viaducts, footbridges and similar structures.
This document essentially comprises :
* a brief description of the product category and of the associated equipment;
* the key regulatory texts;
* the design criteria based...
This technical guide is intended essentially for bridge designers. It provides the information required for the design of elastomeric pot bearings for use on road bridges and viaducts, footbridges and similar structures.
This document essentially comprises :
* a brief description of the product category and of the associated equipment;
* the key regulatory texts;
* the design criteria based on the normative texts prepared by the CEN (European Committee for Standardization);
*a calculation methodology, not for the product itself, but for its use in a bridge project, with a concrete example based on an actual case.
Contents
Chapter 1 - Introduction
General remarks. Purpose and content of the present guide
Application of standard NF EN 1337-5 to the French national context
Chapter 2 - Make-up of a pot bearing
General principles
The constituent parts
Advantages and disadvantages of this type of bearing
Key geometrical dimensions
Chapter 3 - Remarks on standard NF EN 1337- parts 2 & 5 Key points concerning design
Presentation
Introduction
Pot bearings
Chapter 4 – Principles governing calculations for structures comprising pot bearings
Regulatory context
Extreme vertical forces
Longitudinal horizontal forces for sliding pot bearings
Longitudinal horizontal forces for restraint pot bearings
Other recommendations
Examples of calculations
Chapter 5 – Verification of pot bearings
Definition documents
Remarks on verification during service
Appendix 1 - Help in drafting Particular Technical Clauses (CCTP)
A1 -Examples of clauses to be integrated into the “Quality of materials” chapter
A2 -Examples of clauses to be integrated into the “Bearing justification” paragraph of chapter II “Site preparation and organisation” of the Particular Technical Clauses (CCTP)
A3 -Examples of clauses to be integrated into the “Implementation” chapter
Appendix 2 - Pot-bearing characteristic summary sheets
Bibliography
General documents
Standards
En lire plus